carbon conversion for glock 3d print files

However, you can make your own kit by purchasing various parts from different places or our store. It’s important to note that you may not find the entire kit. The required parts for the dd19.2 build are: The required parts for the FMDA dd19.2 are much the same as building any compact or 19 Glock variation Required Parts for the FMDA dd19.2 3D Printed Glock Frame Post-processing: If you print your frame upright, you can clean up the rough bottom-facing areas of your print with a soldering iron – after removing supports, take your soldering iron and melt the rough patches on the frame together to make them smooth.Īll other settings can/should be left as default or whatever you know works best with your printing setup. Keep the fan low to prevent warp.īed Adhesion: gluestick or hairspray or both Your interface gap should not be larger than 0.15mm unless you know what you are doing with your setup.Ĭooling fan: 20% normal, 50% on bridges. Supports: On/full (tree supports are ok) – use a close support interface gap.

Infill: 100% (You can use 99% infill on Cura to speed up the print time) The following suggested print settings are recommended based on using PLA+ filament by the gun developer Ivan the Troll.

The tech specs of the dd19.2 are a blend of the classic compact Glock 19 and the newer P80 compact grip design. FMDA dd19.2 3D Printed Glock Frame Tech Specsįor starters, it’s very important to note that this 3D-printable frame is compatible with the standard compact Glock 19 along with the Glock 22 upper.

The guide also contains various recommendations on where to find the necessary parts, tools needed, and videos. The STL file for 3D printing the dd19.2 was uploaded online in January 2021, along with a full step-by-step guide on how to assemble the parts. His mission was to design a version of the Glock 19 that was much more robust than v1. He considered the feedback from the community on the first-generation frames and the biggest problems that needed to be fixed. Ivan The Troll spent a lot of time on tests and adaptation. The dd19.2 frame is considered an improved, updated version of the original FMDA “dd19” Glock frame( check out the DD20 too). So, this popular DIY gun designer started to work on a new version of the frame around two years ago. This 3D-printable frame was designed by Ivan The Troll.Įven if you haven’t heard of Ivan The Troll before, which is most unlikely, you have probably run into his amazing works, such as the projects UBar2 (AR15 Lower), Colt 3011, Amigo Grande, FMDA dd26.2, and FMDA dd17.2. Dd19.2 Test Fire FMDA dd19.2 3D Printed Glock Frame History

Carbon conversion for glock 3d print files